Which one of the following lists is correctly ordered? Select one: a. Member introduces a bill; one chamber takes floor action; conference committee version is approved. b. Member introduces a bill; president signs/vetoes bill; conference committee version is approved. c. Member introduces a bill; conference committee version is approved; one chamber takes floor action. d. Conference committee approves a bill; member introduces bill; one chamber takes floor action.

the answer is c ( Member introduces a bill; conference committee version is approved; one chamber takes floor action)

Explanation:

The stages of how a bill becomes a law has some steps in which it takes

Firstly, a member of the house will have to introduce the bill i.e a legislation. If any senator objects the legislation is postponed to the next day.

Secondly, - The bill is referred to the appropriate committee by the Speaker of the House or the presiding officer in the Senate. Most often, the actual referral decision is made by the House or Senate parliamentarian. Bills may be referred to more than one committee and can be split and sent to different committees. The Speaker of the House may set time limits on committees.Failure to act on a bill is equivalent to killing it.

Then thirdly is the floor action, the bill is placed on a calendar and is then debated which later then voting on the bill is done. f passed, it is then sent to the other chamber unless that chamber already has a similar measure under consideration. If either chamber does not pass the bill then it dies. If the House and Senate pass the same bill then it is sent to the President

The conference committee acts on the bill which is then forwarded to the President for review, once the president signs it ,the bill becomes a law

question - in 1827, john walker, a druggist in a small english town, tipped a splint with sulphur, chlorate of potash, and sulphid of antimony, and rubbed it on sandpaper, and it burst into flame. the druggist had discovered the first friction-chemical match, the kind we use to-day. it is called friction-chemical because it is made by mixing certain chemicals together and rubbing them. although walker's match did not require the bottle of acid, nevertheless it was not a good one. it could be lighted only by hard rubbing, and it sputtered and threw fire in all directions. in a few years, however, phosphorus was substituted on the tip for antimony, and the change worked wonders. the match could now be lighted with very little rubbing, and it was no longer necessary to have sandpaper upon which to rub it. it would ignite when rubbed on any dry surface, and there was no longer any sputtering. this was the phosphorus match, the match with which we are so familiar. according the paragraph what was the benefit of the new phosphorus match? it burst into flame when rubbed on sandpaper. it was made by mixing chemicals. it could be ignited on any dry surface. it threw fire in all directions.

answer - matches required natural chemicals