Engineering, 17.07.2019 20:30 anthonymw

Acircular cylinder of wall thickness 10 mm and internal diameter 200 mm is subjected to a constant internal pressure of 15 mpa. if the cylinder has closed ends, determine how much (a) axial tensile load, and (b) axial compressive load can be applied to the cylinder before yielding commences according to tresca's maximum shear stress criterion. the yield stress of the material in simple tension is 240 mpa. treat the cylinder as a thin-walled vessel. sketch the plane stress yield locus for the tresca criterion and show the two points representing the cases above. note: the axial stress is one of the stresses that governs the failure.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

You know the right answer?

Acircular cylinder of wall thickness 10 mm and internal diameter 200 mm is subjected to a constant i...

Questions