Engineering, 13.09.2019 23:30 niki209
Acompany gives you a 50mmx6mm (wxh) test coupon that is 0.5 meters in length. they tell you that from their testing, the modulus of rigidity for this material is 80 gpa, and that the yield strength is 300 mpa. they ask you to predict the lateral deformation (width and height) of a 2cmx4cm (wxh) bar they will be using in a design that will be subjected to a 40kn axial tensile load. you test your coupon using a simple tension test, and note that during the test, when the material is within the proportional elastic limit, the coupon deforms 0.012mm when subjected to a load of 1512 n. how much will the bar deform?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 06.07.2019 02:30
1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction
Answers: 1
Engineering, 06.07.2019 04:10
Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg.k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft
Answers: 1
You know the right answer?
Acompany gives you a 50mmx6mm (wxh) test coupon that is 0.5 meters in length. they tell you that fro...
Questions
Mathematics, 13.06.2020 18:57
History, 13.06.2020 18:57
Mathematics, 13.06.2020 18:57
Chemistry, 13.06.2020 18:57
Computers and Technology, 13.06.2020 18:57
