subject
Engineering, 26.09.2019 16:10 Day1201

The flow is turned using a compression ramp and an expansion corner. if the approach flow mach number is, m=3, approach flow static pressure is, p1=1 atm, and the ramp angle is 10 degrees, a) (10 pts) calculate the mach number after the compression ramp. b) (10 pts) calculate the flow turning angle, t, required to achieve m=3 after the expansion corner. c) (10 pts) calculate the total pressure after the compression corner. d) (10 pts) calculate the static pressure after the expansion corner.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60Ā°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
You know the right answer?
The flow is turned using a compression ramp and an expansion corner. if the approach flow mach numbe...
Questions
question
Mathematics, 17.03.2020 22:23
Questions on the website: 13722361