Engineering, 29.10.2019 06:31 LilDicky

2. (30 points) the shark tank at an aquarium houses 5 sharks that deplete the aquarium water of a total of 60.00 g of oxygen per hour. water from the tank is diverted through a bubbler unit that oxygenates the water using a stream of oxygen-rich air, and then is returned to the tank. at steady state, water enters the bubbler containing 0.000700 wt% o2 and exits the bubbler containing 0.001000 wt% o2. for every kilogram of the inlet water stream that enters the bubbler, 0.00500 mol of oxygen-rich air with an initial composition of 25.00 mole% o2 and 75.00 mole% n2 is fed through the bubbler. draw and label a flowchart for the process described. perform a degree of freedom analysis (dof) of the process. what are the flow rates of water entering the tank? what is the composition (in wt %) of the outlet air leaving the tank?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.

Answers: 3

Answer

Engineering, 06.07.2019 04:20

Steam enters a turbine at steady state at 2 mpa, 360°c with a velocity of 100 m/s. saturated vapor exits at 0.1 mpa and a velocity of 50 m/s. the elevation of the inlet is 3 m higher than at the exit. the mass flow rate of the steam is 15 kg/s, and the power developed is 7 mw. let g 9.81 m/s^2. determine: a)-the area at the inlet, in m^2 b)-the rate of heat transfer between the turbine and surroundings, in kw c)-draw a p-v diagram for this process.

Answers: 1

Answer

Engineering, 06.07.2019 05:30

Around steel bar, 20 mm in diameter and 400 mm long, is placed concentrically within a brass long. tube which has an outside diameter of 30 mm and thickness 4 mm. the tube is 400 mm the upper end of the vertically placed compound bar is rigidly fixed and a collar is fitted to the bottom end. the application of a load p results in the compound rod storing a total of 5 j of energy.calculate (a) the gradually applied load; (b) the suddenly applied load; (c) the impact load that falls 100 mm and induces 5 j of energy; (d) the instantaneous stresses in both materials; and (e) the instantaneous elongation of the compound rod (egt = 200 gpa and egr = 100 gpa).

Answers: 2

Answer

You know the right answer?

2. (30 points) the shark tank at an aquarium houses 5 sharks that deplete the aquarium water of a to...

Questions