Engineering, 08.11.2019 07:31 dlasheab
Athick steel slab (rho = 7800 kg/m , c = 480 j/kg⋅k, k = 50 w/m ⋅ k) is initially at 300°c and is cooled by water jets impinging on one of its surfaces. the temperature of the water is 25°c, and the jets maintain an extremely large, approximately uniform convection coefficient at the surface. assuming that the surface is maintained at the temperature of the water throughout the cooling, how long will it take for the temperature to reach 50°c at a distance of 25 mm from the surface?
Answers: 2
![\frac{T(x,t)-Ts}{Ti-Ts} =erf(\frac{x}{2\sqrt[]{\alpha t} } )](/tpl/images/0365/2796/d8c46.png)
![\frac{50-25}{300-25} =erf(\frac{x}{2\sqrt[]{\alpha t} } )](/tpl/images/0365/2796/7b5c1.png)
![\frac{x}{2\sqrt[]{\alpha t} }=0.0909](/tpl/images/0365/2796/2d993.png)
![\frac{x}{2\sqrt[]{\alpha t} }=0.0807](/tpl/images/0365/2796/984dc.png)
Another question on Engineering
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
You know the right answer?
Athick steel slab (rho = 7800 kg/m , c = 480 j/kg⋅k, k = 50 w/m ⋅ k) is initially at 300°c and is co...
Questions
Mathematics, 07.12.2020 16:50
Mathematics, 07.12.2020 16:50
Chemistry, 07.12.2020 16:50
Computers and Technology, 07.12.2020 16:50
History, 07.12.2020 16:50
Mathematics, 07.12.2020 16:50
History, 07.12.2020 16:50
Mathematics, 07.12.2020 16:50
Chemistry, 07.12.2020 16:50
