Engineering, 11.11.2019 23:31 drecooks713
It is required to design a zener shunt regulator to provide a regulated voltage of about 10 v. the available 10-v, 1-w zener of type 1n4740 is specified to have a 10-v drop at a test current of 25 ma. at this current, its rz is 7 . the raw supply, vs , available has a nominal value of 20 v but can vary by as much as ±25%. the regulator is required to supply a load current of 0 ma to 20 ma. design for a minimum zener current of 5 ma.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 19:20
Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection
Answers: 1
You know the right answer?
It is required to design a zener shunt regulator to provide a regulated voltage of about 10 v. the a...
Questions
Mathematics, 07.05.2020 14:01
Computers and Technology, 07.05.2020 14:01
Mathematics, 07.05.2020 14:01
