Engineering, 06.03.2020 23:27 kaybreezy

A fluid flows in the positive x-direction through a long flat duct of length , width W, and thickness , where ≫ W ≫ . The duct has porous walls at y = 0 and y = , so that a constant cross flow can be maintained, with y = 0, a constant, everywhere. Flows of this type are important in connection with separation processes using the sweep-diffusion effect. By carefully controlling the cross flow, one can concentrate the larger constituents (molecules, dust particles, etc.) near the upper wall.

a. Find the velocity profile, v.(y), by taking the coordinate system with y =0 at the midplane of the slit with the porous walls located at y±B.
b. Calculate the mass flow rate in x-direction.
c. Show that the mass flow rate obtained in section (b) is simplified to mass flow rate for laminar flow in slit when v= 0.
d. According to your calculations in part (b) and (c), does the cross flow in y-direction change the mass flow rate in x-direction? Why (explain it)?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

Answer

Engineering, 06.07.2019 02:30

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

Answer

You know the right answer?

A fluid flows in the positive x-direction through a long flat duct of length , width W, and thicknes...

Questions