Engineering, 13.03.2020 18:12 finldani4

1. On the Smith chart, movements along a transmission line are plotted as a function of the wavelength. The wavelength can be related to the frequency if the physical characteristics of the transmission line are known; in the case of the coaxial cable, for example, knowledge of the dielectric constant will allow us to relate frequency to wavelength. Assume a coaxial cable of relative dielectric constant & = 2.25. Given a 30 cm cable, determine the length of the cable in terms of wavelengths for the following frequencies. (1 pts) a. 100 MHz (for example Ans: length 30 cm = 0.15* 2 = 0.3 * 1/2) b. 333.33 MHz c. 600 MHz d. 1000 MHZ Electrical length (EL) Frequency 100 MHz 333.33 MHz 600 MHz 1000 MHZ Length of the cable 30 cm 30 cm 30 cm 30 cm

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

You know the right answer?

1. On the Smith chart, movements along a transmission line are plotted as a function of the waveleng...

Questions