Engineering, 16.03.2020 18:44 nessuhbae6722

A convergent–divergent nozzle is designed to expand air from a chamber in which the pressure is 800 kPa and the temperature is 40°C to give Mach 2.5. The throat area of the nozzle is 0.0025 m2. Find a. The flow rate through the nozzle under design conditions b. The exit area of the nozzle c. The design back-pressure and the temperature of the air leaving the nozzle with this back-pressure d. The lowest back-pressure for which there is only subsonic flow in the nozzle e. The back-pressure at which there is a normal shock wave on the exit plane of the nozzle f. The back-pressure below which there are no shock waves in the nozzle g. The range of back-pressures over which there are oblique shock waves in the exhaust from the nozzle h. The range of back-pressures over which there are expansion waves in the exhaust from the nozzle i. The back-pressure at which a normal shock wave occurs in the divergent section of the nozzle at a point where the nozzle area is half way between the throat and the exit plane areas

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 19:10

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

Answer

You know the right answer?

A convergent–divergent nozzle is designed to expand air from a chamber in which the pressure is 800...

Questions