Engineering, 26.03.2020 16:52 destinywashere101
Measurements of drag force are made on a model automobile in a towing tank filled with fresh water. The model length scale is 1/8 that of the prototype. Let FD = f(rho, V, L, μ).
a. State the conditions required to ensure a dynamic similarity between the model and prototype.
b. Determine the fraction of the prototype speed in the air at which the model test should be made in water to ensure dynamically similar conditions.
c. Measurements made at various speeds show that the dimensionless force ratio becomes constant at model test speeds above Vm = 6 m/s. The drag force measured during a test at this speed is FDm = 193 N. Calculate the drag force expected on the prototype vehicle operating at 97 km/hr in the air.
Answers: 3
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Measurements of drag force are made on a model automobile in a towing tank filled with fresh water....
History, 02.03.2020 17:56
Social Studies, 02.03.2020 17:56
Mathematics, 02.03.2020 17:57
Mathematics, 02.03.2020 17:57