Engineering, 16.04.2020 23:35 lzrd3rik
A stream of humid air containing 1.50 mole% H_2O(v) and the balance dry air is to be humidified to a water content of 10.0mole% H_2O. For this purpose, liquid water is fed through a flowmeter and evaporated into the air stream. The flowmeter reading. R, is 95. The only available calibration data for the flowmeter are two points scribbled on a sheet of paper, indicating that readings R = 15 and R = 50 correspond to flow rates V = 40.0 ft^3/h and V = 96.9 ft^3/h, respectively. (a) Assuming that the process is working as intended, draw and label the flowchart, do the degree-of-freedom analysis, and estimate the molar flow rate (Ib-mole/h) of the humidified (outlet) air if (i) the volumetric flow rate is a linear function of R and (ii) the reading R is a linear function of V. (b) Suppose the outlet air is analyzed and found to contain only 7% water instead of the desired 10%. List as many possible reasons as you can think of for the discrepancy, concentrating on assumptions made in the calculation of Part (a) that might be violated in the real process.
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 Β°f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Engineering, 04.07.2019 19:10
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
Engineering, 04.07.2019 19:10
When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?
Answers: 2
A stream of humid air containing 1.50 mole% H_2O(v) and the balance dry air is to be humidified to a...
Mathematics, 04.12.2019 00:31
Mathematics, 04.12.2019 00:31
Mathematics, 04.12.2019 00:31
Advanced Placement (AP), 04.12.2019 00:31
Mathematics, 04.12.2019 00:31
Chemistry, 04.12.2019 00:31
History, 04.12.2019 00:31
History, 04.12.2019 00:31