Engineering, 21.04.2020 22:39 jbismyhusbandbae

A novel gaseous hydrocarbon fuel CxHy is proposed for use in spark-ignition engines. An analysis of a sample of this fuel revealed that its molecular weight is 140 and its molar H/C ratio is 2.0. In order to evaluate some of its properties, the fuel was burned with stoichiometric standard air in a constant pressure, steady-flow reactor. The fuel and air entered the reactor at 25°C, and the products of complete combustion were cooled to 25°C. At the exit condition, water in the products was a liquid. It was measured that the heat given off during the process to the cooling system of the reaction was 47.5 MJ/kg of fuel. a) Determine the fuel formula. b) What does that heat given-off to the cooling system of the reactor represent? c) Determine the lower heating value of the fuel. d) Determine the enthalpy of formation of the fuel at 25°C

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing

Answers: 3

Answer

You know the right answer?

A novel gaseous hydrocarbon fuel CxHy is proposed for use in spark-ignition engines. An analysis of...

Questions