subject
Engineering, 24.04.2020 21:46 emmanuellugo40

An arrival rate of 720 veh/h arrive at a single lane signalized approach that is controlled by a traffic signal that operates at a cycle length of 60 seconds and a 50:50 green split. The amber and all-red interval is 5 seconds. The unopposed saturation flow rate was measured to be 1800 veh/h/lane with a start-loss 2 seconds and end gain of 3 seconds, respectively. For the approach do the following for a single cycle length:

a. Compute the maximum queue size formed upstream the traffic signal.

b. Compute the time required to dissipate the queue.

c. Compute the average vehicle delay experienced by vehicles traveling on the approach using the macroscopic procedures that were described in the class.

d. Compute the average vehicle delay experienced by vehicles traveling on the approach by tracking the arrival and departure times of each vehicle. Assume the first vehicle arrives at the midheadway after the red interval starts.

e. Repeat part (d) considering the first vehicle arrival ranges from 0 to 5 seconds. Comment on the sensitivity of delay estimates to the arrival time of the first vehicle.

f. Compute the number of vehicles that come to a complete stop during the cycle length.

g. Compute the maximum delay experienced by a vehicle.

h. What is the delay experienced by the third vehicle in queue assuming that the first vehicle arrives at the start of the red.

The Cycle length is 60 seconds. The problem should be solved fo a single cycle length.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 04.07.2019 19:10
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
You know the right answer?
An arrival rate of 720 veh/h arrive at a single lane signalized approach that is controlled by a tra...
Questions
question
Mathematics, 21.06.2021 08:10
question
Mathematics, 21.06.2021 08:10
Questions on the website: 13722360