Engineering, 05.06.2020 04:02 rbgrh5779

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 800 kpa and the temperature is 40 c to give mach no 2.5 the throat are for the nozzle is .0025m2 1- The flow rate through the nozzle under design conditions
2- The exit area of the nozzle
3- The design back-pressure and the temperature of air leaving nozzle with this back pressure
4-The lowest back-pressure for which there is only subsonic flow in the nozzle
5- The back-pressure at which there is a normal shock wave on the exit plane of nozzle
6- The back-pressure below which there are no shock waves in the nozzle
7-The range of back-pressures over which there are oblique shock waves in the exhaust from the nozzle
8- The range of back-pressures over which there are expansion waves in the exhaust from the nozzle
9- The back-pressure at which a normal shock wave occurs in the divergent section of the nozzle at a point where the nozzle area is half way between throat and exit plane the throat and exit plane areas.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

You know the right answer?

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 8...

Questions