Engineering, 01.02.2021 23:00 trmcswain03

Let’s say I have two cylindrical segments of polymer that I’m testing in tension: The two materials are made of an identical substance, and the force applied to both is identical. In the undeformed state, the second cylinder has a cross-sectional area equal to half that of the first cylinder. Assume incompressible material with linear elasticity; no plastic deformation occurs.
A. How does the engineering (i. e. nominal) stress differ in the two samples?
B. How does the engineering (i. e. nominal) strain differ in the two samples?
C. How does the expected change in length differ in the two samples?
D. How does the true stress differ in the two samples?
E. How does the true strain differ in the two samples?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

You know the right answer?

Let’s say I have two cylindrical segments of polymer that I’m testing in tension: The two materials...

Questions