Engineering, 12.02.2021 01:40 LittlestRedTeal8940
A cone clutch with cone angle 20° is to transmit 7.5 kW at 750 c. p.m. The normal intensity of pressure
between the contact faces is not to exceed 0.12 N/mm2. The coefficient of friction is 0.2. If face width
is Yth of mean diameter, find : 1. the main dimensions of the clutch, and 2. axial force required
while running.
[Ans. R = 117 mm : b = 46.8 mm : r1 = 125 mm : r2 = 109 mm : 1395 N]
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
You know the right answer?
A cone clutch with cone angle 20° is to transmit 7.5 kW at 750 c. p.m. The normal intensity of press...
Questions
English, 06.09.2019 17:30
Computers and Technology, 06.09.2019 17:30
Computers and Technology, 06.09.2019 17:30
Geography, 06.09.2019 17:30
Medicine, 06.09.2019 17:30
