subject
Engineering, 22.02.2021 19:00 lrasanaoaksandfurana

The following spot speeds were measured at a location along a two-lane highway (for one direction only), over a period of 10 minutes. 69 54 67 69 58 62 57 61 63 58 60 60 58 54 57 60 71
65 57 63 69 69 59 54 60 67 58 46 53 59 62 54 58 68
66 59 57 64 58 52 61 65 61 53 58 57 65 47 64 54 68
59 59 62 57 66 67 58 64 60 59 59 63 56 62 64 59 57
61 61 58 57 64 70

Calculate the following traffic stream parameters:

a. Time mean speed
b. Space mean speed (assume that all vehicles were traveling at a constant speed)
c. Hourly flow rate
d. Density
e. Sketch the speed-flow curve for these traffic conditions, assuming that the roadway capacity and free-flow speed have previously been determined to be 1800 veh/h/In and 62 mill, respectively.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:20
Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false
Answers: 2
You know the right answer?
The following spot speeds were measured at a location along a two-lane highway (for one direction on...
Questions
question
Mathematics, 18.04.2021 03:00
question
Mathematics, 18.04.2021 03:00
question
Mathematics, 18.04.2021 03:10
Questions on the website: 13722360