Engineering, 24.03.2021 19:50 syulerio8418

Chapter 16 Architecture: Problem solving case study question You have been asked to create a landscaping plan for the home shown in figure A. The basic footprint of the house is 40' wide by 20' deep, and it sits parallel with the edges of the rectangular 96' by 64' building lot. The front right corner of the house is 28' from the right property line and 23' from the front property line. The land slopes evenly from back to front across the width of the property. The elevation at the back property line 146', and the elevation at the front property line is 132'. A 12'- wide driveway will run from the front of the property to the right side if the house. The house is located in Muncie, Indiana.

Given this information, create a landscaping plan of the house. Be sure to specify plants that are native to the area. Keep the contour of the site in mind and develop a plan that will reduce water runoff.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

Chapter 16 Architecture: Problem solving case study question You have been asked to create a landsc...

Questions