Engineering, 19.04.2021 18:10 cylertroutner

Based on your understanding of color’s relationship to wavelength, identify the approximate wavelength of light (nm) emitted by strontium when it was burned in Part C. (No quantitative data was collected for this; you are giving an approximate value only, based on what you observed.) Strontium emission = nm Explain your reasoning in full, making sure to cite specific data and observations to support your answer.

Q.5 What would you conclude about chloride based on your results in the flame tests in Part C?

Q.6 Place the metal solutions you tested in order of increasing energy based on the colors observed in the flame test; i. e., A < B < C.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

Based on your understanding of color’s relationship to wavelength, identify the approximate waveleng...

Questions