subject
Engineering, 19.05.2021 18:40 davelopez979

Air enters the compressor of a simple gas turbine at 0.1 MPa, 300 K. The pressure ratio is 9 and the maximum temperature is 1000 K. The turbine process is divided into two stages, each with a pressure ratio of 3, with intermediate reheating to 1000 K. Use the PG model. What would the answers be if the reheat were eliminated?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Air enters the compressor of a simple gas turbine at 0.1 MPa, 300 K. The pressure ratio is 9 and the...
Questions
question
History, 01.12.2020 01:10
question
Mathematics, 01.12.2020 01:10
question
Mathematics, 01.12.2020 01:10
question
History, 01.12.2020 01:10
Questions on the website: 13722362