Engineering, 29.06.2021 04:30 ekids22

1)In this experiment, the weights are added sequentially (ON,5N, 10N,15N,20N) for the first spin, the position of the middle pulley and the position of the dynamometer are in the same unit (i. e. on one line) a) Calculate the tensile values for T1 and T2 in this case. 2)The dynamometer is moved one unit up and the center pulley position will decrease. Note One unit is 0.5cm. a)Calculate the mechanical work on the pulley from the law. (Work on pulley=FS=FStr) b)Calculate the mechanical work on a dynamometer from the law. (Work on dynamometer-FS=FSm) Discussion 1) Draw on graph paper a diagram of the relationship between the weight on the pulley and the value of tension T1 and T2. 2) Draw on graph paper a diagram of the relationship between displacement on the pulley and displacement on the dynamometer. 3) Discuss the results

1)In this experiment, the weights are added sequentially (ON,5N, 10N,15N,20N) for the first spin, t

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

You know the right answer?

1)In this experiment, the weights are added sequentially (ON,5N, 10N,15N,20N) for the first spin, th...

Questions