Engineering, 29.06.2021 17:30 chrismax8673
he following applies to the next five questions, which concern a bolted tension joint. Further data will be supplied as necessary: stiffness coefficient of the joint 0.237 nominal fastener diameter 20 mm Tensile stress area 245 mm2 Proof strength 380 MPa Pre-load 51.2 kN Find the external load that would just cause joint separation.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
You know the right answer?
he following applies to the next five questions, which concern a bolted tension joint. Further data...
Questions
History, 23.06.2019 06:30
Biology, 23.06.2019 06:30
Computers and Technology, 23.06.2019 06:30
History, 23.06.2019 06:30
History, 23.06.2019 06:30
History, 23.06.2019 06:30
