Happy rakhi
to me brother and sister
...
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
Engineering, 06.07.2019 04:10
Steam enters a converging-diverging nozzle at 1.0 mpa and 500°c with a negligible velocity at a mass flow rate of 2.5 kg/s, and it exits at a pressure of 200 kpa. assuming the flow through the nozzle to be isentropic, determine: the exit area and (a) (b) the exit mach number
Answers: 2
You know the right answer?
Questions
Mathematics, 01.04.2021 15:30
History, 01.04.2021 15:30
Biology, 01.04.2021 15:30
English, 01.04.2021 15:30
Advanced Placement (AP), 01.04.2021 15:30
English, 01.04.2021 15:30
Mathematics, 01.04.2021 15:30
Mathematics, 01.04.2021 15:30
Mathematics, 01.04.2021 15:30
Mathematics, 01.04.2021 15:30
