1) if the specification is such that no washer should be greater than 2.4 millimeters, assuming that the thicknesses are distributed normally, what fraction of the output is expected to be greater than this thickness?

h

step-by-step explanation:

good luck on your studies! : )

david edward.

the system of inequalities is

step-by-step explanation:

step 1

find the equation of the dashed line

we have the points

(0,0) and (3,1)

the line passes through the origin, so, is a direct variation

find the slope

the equation of the dashed line is

the solution of the inequality a s the shaded area above the dashed line

therefore

the equation of the inequality a is

step 2

find the equation of the solid line

we have the points

(4,0) and (0,4)

find the slope

the equation of the solid line is

the solution of the inequality b s the shaded area below the solid line

therefore

the equation of the inequality b is

step 3

the system of inequalities is

when rotating a figure 180 degrees, imagine that you are able to take the figure and turn it clockwise or counterclockwise around a center point. to rotate a figure 180 degrees, you will need to apply the rule (x, y) → (-x, -y). start by using a coordinate grid with coordinates for each vertex of the figure. the center point of the coordinate grid is located at (0, 0), which is what you will rotate the figure around. write down the original coordinates of the shape you are going to rotate. then, apply the rule. for example, coordinate (1, 2) becomes (-1, -2). another example would be, coordinate (-4, -2) becoming (4, 2). after you change each original coordinate to the rotated coordinate, you will draw your new figure.

step-by-step explanation: