In order to create two-dimensional geometry such as lines, arcs, and rectangles, what mode should solidworks be in?

d

step-by-step explanation:

d

for the friend request.

when a figure, such as triangle (xyz) is reflected over the line y = x to create x'y'z' the x-coordinates and y-coordinates of the original image (pre-image) will be reversed for the image. (e.g., (x, y) > (y, x)) this means that the pre-image position of the x- and y-coordinates switch places which in turn provides a mirror like image of the original xyz.  

i notice that when i draw a line segment from x to x', that the points are parallel from each other -- they are exactly across from each other and do not intersect with any other points.  

yes, think i would see the same characteristic if you drew the line segment connecting y with the reflecting line and then y' with the reflecting line because of the essence of reflections. because it is a mirror image, each point was effected the same way which leads me to conclude that they same would apply to y and y'.

step-by-step explanation:

one of the most important purposes of surface treatment is to alter surface properties according to the requirement of specific applications. for example, hydrophobic coating has been utilized on windshield and eyeglasses. gold atom monolayer on substrate has become a popular surface bioconjugation strategy.