I) Kinetic Energy (high-pressure
steam)

II) Kinetic Energy
(spinning turbine)

III) Intranuclear Potential
Energy (uranium)

IV) Kinetic Energy
(electricity in
transmission lines)

V) Kinetic Energy
(generator)

In what order do these phases occur in the energy conversion of a nuclear power plant?

A. I, II, III, V, IV
B. I, III, II, V, IV
C. III, I, II, IV, V
D. III, I, II, V, IV

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Two polarizers are oriented at 24.0∘ to one another. light polarized at a 12.0-degree angle to each polarizer passes through both. what is the transmitted intensity (%)?

Which of the following are not typically included in the periodic table? a. atomic mass b. element symbol c. isotopes d. number of electrons