Physics, 04.01.2021 18:20 rayne40

1. A series circuit has three resistors, each on different paths and connected to a 120 V battery. Resistor 1 has a resistance of 5.0 Ω, Resistor 2 has a resistance of 7.5 Ω, and Resistor 3 has a resistance of 9.5 Ω. Create the circuit using the PhET simulator, and then draw a picture of the circuit you made. Then, fill in the table below for this circuit. Show your work completed. Measurements and the corresponding units Resistor 1 Resistor 2 Resistor 3 Total V (volts) 120 V I (A – amperes) R (Ω – ohms) 5.0 Ω 7.5 Ω 9.5 Ω P (W – work) Show your work: I=Vtotal/Rtotal. This gives you the total, I, which then allows you to calculate Ohm’s law for the other individual resistors. The total voltage spread across the three resistors should equal the total number of voltage periods. The power is determined by P 5 I 3 V.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 10:30

Agroup of students were investigating the force of gravity. they began by dropping a foam ball from a height of 3 meters into a bucket of sand. the ball hit the sand in 0.306 seconds. they dropped additional balls of approximately the same diameter, but of different masses. here is the data they collected. based on this experiment and the collected data, what would their conclusion be?

Answers: 1

Answer

Physics, 22.06.2019 18:00

Astudent weighing 700 n climbs at constant speed to the top of an 8 m vertical rope in 10 s. the average power expended by the student to overcome gravity is most nearly

Answers: 2

Answer

Physics, 23.06.2019 05:30

The reason a penny thrown straight up inside a bus will come back to your hand is that you,the bus,the air inside the bus, and the penny are all moving at the same velocity. true or false

Answers: 2

Answer

Physics, 23.06.2019 08:00

Which of the following is a false statement about dispersion forces? view available hint(s) which of the following is a false statement about dispersion forces? dispersion forces are the result of fluctuations in the electron distribution within molecules or atoms. dispersion forces are present in all atoms and molecules. dispersion forces result from the formation of instantaneous dipoles in a molecule or atom. dispersion forces always have a greater magnitude in molecules with a greater molar mass. dispersion force magnitude depends on the amount of surface area available for interactions.

Answers: 1

Answer

You know the right answer?

1. A series circuit has three resistors, each on different paths and connected to a 120 V battery. R...

Questions