Physics, 26.03.2021 19:10 abigailweeks10

For each of the three simple circuit boards you will need to calculate the total resistance Reg for the entire circuit board by using the measured resistances of each of the resistors, and the equations given to you in the theory section. Then using the applied voltage of 2V, as the theoretical voltage Vth for the entire circuit board you can calculate the theoretical current, it, for the entire circuit board. Table 1(Resistors in series) calculate R(Q) lex(A) Vex(V) ith(A) Ven(V) % Error i % Error V Reo 305, 2 .00u61 1.9864 100 10.4 .006 .0681 1000 99.62 .0064 .6484 2000 195 00660 1.26% 1. Using the equations for resistors in series calculate the theoretical voltages, and currents for each of the resistors, and the entire circuit. Use the measured values of the resistance in your calculations. Then calculate the % errors. Show work. (20 points) 2. According to our equations, what should be the relationship between the total current and the currents passing through each resistor? Does your data show this relationship? (5 points) do c on loot boenlu oy sombra Vi b o rbe to zostabacom sudbredt voor das vogalov bolagsstarostovo 3. According to our equations, what should be the relationship between the total voltage and the voltages passing over each resistor? Does your data show this relationship? (5 points) com d an bisa

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 06:00

The frequency of vibrations of a vibrating violin string is given by f = 1 2l t ρ where l is the length of the string, t is its tension, and ρ is its linear density.† (a) find the rate of change of the frequency with respect to the following. (i) the length (when t and ρ are constant) (ii) the tension (when l and ρ are constant) (iii) the linear density (when l and t are constant) (b) the pitch of a note (how high or low the note sounds) is determined by the frequency f. (the higher the frequency, the higher the pitch.) use the signs of the derivatives in part (a) to determine what happens to the pitch of a note for the following. (i) when the effective length of a string is decreased by placing a finger on the string so a shorter portion of the string vibrates df dl 0 and l is ⇒ f is ⇒ (ii) when the tension is increased by turning a tuning peg df dt 0 and t is ⇒ f is ⇒ (iii) when the linear density is increased by switching to another string df dρ 0 and ρ is ⇒ f is ⇒

Answers: 3

Answer

Physics, 22.06.2019 15:50

The space between two 15-in.-long concentric cylinders is filled with glycerin (viscosity = 8.5 × 10-3 lb·s/ft2). the inner cylinder has a radius of 1 in. and the gap width between cylinders is 0.1 in. determine (a) the torque and (b) the power required to rotate the inner cylinder at 180 rev/min. the outer cylinder is fixed. assume the velocity distribution in the gap to be linear.

Answers: 2

Answer

Physics, 23.06.2019 00:30

Due in 40 explain in terms of frame of reference if you’re inside a moving train everything on the outside can seem to be moving

Answers: 1

Answer

Physics, 23.06.2019 01:30

In general what determines whether atoms will form chemical bonds?

Answers: 2

Answer

You know the right answer?

For each of the three simple circuit boards you will need to calculate the total resistance Reg for...