subject
Physics, 29.09.2019 08:30 erinkiing

Amonatomic ideal gas undergoes an isothermal expansion at 300 k, as the volume increased from 0.010 m3 to 0.040 m3. the final pressure is 130 kpa. what is the change in the internal (thermal) energy of the gas during this process? (r = 8.31 j/mol ⢠k)

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 03:00
Ahot-air balloonist, rising vertically with a constant speed of 5.00 m/s releases a sandbag at the instant the balloon is 40.0 m above the ground. after it is released, the sandbag encounters no appreciable air drag. compute the velocity of the sandbag at 0.250 s after its release.
Answers: 2
question
Physics, 22.06.2019 11:30
This punnett square shows the cross between two pants. one parent has round seeds (rr). and the other parent has wrinkled seeds (rr) which best describes their offspring as shown in this cross?
Answers: 1
question
Physics, 23.06.2019 02:10
You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 3.00 ms . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?
Answers: 1
question
Physics, 23.06.2019 02:10
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
You know the right answer?
Amonatomic ideal gas undergoes an isothermal expansion at 300 k, as the volume increased from 0.010...
Questions
Questions on the website: 13722359