Physics, 03.12.2021 20:20 willcohen42

When a 2.0 µF capacitor is connected to a generator whose rms output is 29 V, the current in the circuit is observed to be 0.35 A. What is the frequency of the source?

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

Glass is transparent to visibile light under normal conditions; however, at extremely high intensities, glass will absorb most of the light incident upon it. this works through a process known as multiphoton absorption. in this process, several photons are absorbed at the same time. if very intense light whose photons carry 2ev of energy is shined onto a material with a band gap of 4ev, that light can be absorbed through two-photon absorption, because two photons have the right amount of energy to bridge the band gap. what is the minimum number of photons of 800-nm light that are needed to equal or exceed the band gap of fused silica glass

Answers: 1

Answer

Physics, 22.06.2019 07:40

Astudent creates a model of a closed ecosystem by filling a glass tank half full with water, then adding 10 snails and two small aquatic plants. the next day, all the snails are dead. what is the most likely cause of their death?

Answers: 3

Answer

Physics, 22.06.2019 15:00

Amoving company collects data about couches they move and displays the data in a table. the force along the ramp, the angle of the ramp, and the height the couch is raised to are shown. which statements correctly compare the work done to move the couches? check all that apply. the same amount of work is done for couches 1 and 3. the same amount of work is done for couches 2 and 3. the work for couch 1 is greater than the work for couch 2. the work for couch 2 is less than the work for couch 3. the work for couch 3 is greater than the work for couch 1. the work for couch 2 is greater than the work for couch 1.

Answers: 1

Answer

Physics, 22.06.2019 20:50

Asquare 1m x 1m plate is shown below. all four of its edges are kept at 0 co. at t=0the temperature distribution is given by: y xtsins n75)=.a) using separation of variables determine the temperature distribution t(x,y,t)along the plate at any time t.b) discretize the heat conduction equation +=22222 txtusing a second-order centered difference scheme for the two second derivatives and a first-order forward euler scheme for the first derivative. using von neumann stability analysis, determine the stability criterion for the proposed discretization scheme in terms of , hand t. solve for the maximum allowable time step tmax

Answers: 1

Answer

You know the right answer?

When a 2.0 µF capacitor is connected to a generator whose rms output is 29 V, the current in the cir...

Questions