Physics, 02.02.2022 21:00 DerekMoncoal

How does an electric generator work? The axle rotates the armature in the magnetic field of a permanent magnet, which induces an electric current. The armature rotates the axle in the magnetic field of a permanent magnet, which induces an electric current. The axle rotates the armature in the magnetic field of an electromagnet, which induces an electric current. The armature rotates the axle in the magnetic field of an electromagnet, which induces an electric current.

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 01:10

The 10-kg double wheel with radius of gyration of 125mm about o is connected to the spring of stiffness k = 600 n/m by a cord which is wrapped securely around the inner hub. if the wheel is released from rest on the incline with the spring stretched 225 mm, calculate the maximum velocity v of its center o during the ensuing motion. the wheel rolls without slipping

Answers: 1

Answer

Physics, 22.06.2019 10:30

An insulated 40 ft^3 rigid tank contains air at 50 psia and 120°f. a valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 25 psia. the air temperature during this process is kept constant by an electric resistance heater placed in the tank. determine the electrical work done during this process.

Answers: 2

Answer

Physics, 22.06.2019 21:00

Acentrifuge in a medical laboratory rotates at an angular speed of 3,700 rev/min. when switched off, it rotates through 54.0 revolutions before coming to rest. find the constant angular acceleration (in rad/s2) of the centrifuge. your response is within 10% of the correct value. this may be due to roundoff error, or you could have a mistake in your calculation. carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. rad/s2

Answers: 1

Answer

Physics, 22.06.2019 21:40

Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.

Answers: 1

Answer

You know the right answer?

How does an electric generator work? The axle rotates the armature in the magnetic field of a perman...

Questions