Engineering, 10.03.2020 17:34 sis212

1. Given that increased temperature will (all things being equal), decrease the amount of pressure required to extrude at a given rate; what limits increasing this process variable to increase process speed?
2. Given that the material we are extruding is a crystalline thermoplastic, if we wanted it to stay clear once it cooled what process step would be added to our extrusion line?

Answers: 2

Show answers

Answers

Answer from: beeboppity

Answer & Explanation:

Whichever way heat is supplied to the barrel. It is necessary that the temperature inside the barrel must be maintained at optimum levels. If the heat supplied exceed what is needed, the granules will form a useless fluid. However, if heat supplied is less than required, it affects the flow rate of granules, that is, flow rate of granules will be non-uniform and abrupt

The temperature of barrel is therefore maintained by continuous flow of air over it The air either flows over the barrel by natural circulation or forced convection

(1) Increase in temperature or overheating will have affect the characteristic of the granules by reducing their viscosity which will consequently affect the reliability of granules. Thus, overheating limits increasing the process variable to increase process speed

Note

It is possible that when the molten plastic is coming out of the die orifice the granules will be aligned in the direction parallel to the axis of orifice

When no constraint is provided, the molecules will be contracted in the direction of extrusion and this will block the exit for the extrusion process. This phenomenon is known as die swell.

(2) To prevent die swell in the case of the crystalline thermoplastic materials, the extrusion line must ensure that

There is decrease in the rate of extrusion from the die orifice

There is an increase in the length of the die land

reaction catalyst or additives are added to increase the melt temperature of the granules

Answer from: Quest

answer:

d. attempt to find the owner, then leave your information if you cannot find them.

explanation:

d. represents both (b) and (c).

more logical as well.

b and c are to complicated.

glad i could , give me a follow, so if you need with any other question, im here.

Answer from: Quest

angvrswer:

vfg

grfhrtrhr:

jjj

yjujuju

jujuhuyhyt

bgf

bgr

gbr

bgr

gtr

bgr

gbgbbg

bgg

bbg

bfg

dcwf

fdb

ggb

rfe

gtg

gegte

gff

dfg

gfdsax

cvfbgnh

jmhngf

dsaazxscvb

nmhgb

fvdcsxaz

zxcv

bghn

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the main objective of using reheat rankine cycle?

Answers: 3

Answer

You know the right answer?

1. Given that increased temperature will (all things being equal), decrease the amount of pressure r...

Questions