Engineering, 07.05.2021 16:00 bneilesauger

A solid steel spindle shaft of circular cross section is to be used to support a ball bearing idler pulley. The inner raceof the ball bearing is attached to the fixed non-rotating shaft. The rotating pulley is attached to the outer race of the ball bearing. The bearing is single-row 02-series deep-groove. Based on the preliminary stress analysis of the shaft, it must have at least a 1.63 inches outside diameter. The Weibull parameters are x0= 0.020, theta=4.459,and b = 1.483. The following information is given for your calculation. a) Calculate the catalog rating C10for the ball bearing(10 points)
b) Select the smallest acceptable bearing (bore)from Table 11-2(5 points)
c) If the selected ball bearing in b) is usedfor this application, estimate the reliability of the selected ball bearing.(10 points)

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

You know the right answer?

A solid steel spindle shaft of circular cross section is to be used to support a ball bearing idler...