Mathematics, 22.03.2020 19:59 ilovemilk1981

The probability density function shown models the amount of rainfall per year for a certain location. If the area of each square on the grid is 0.05, estimate the probability that the rainfall for the year is less than 8 inches.

The probability density function shown models the amount of rainfall per year for a certain location

Answers: 1

Show answers

Another question on Mathematics

Mathematics, 21.06.2019 15:00

What is the value of the expression below? (81^2)^1/8

Answers: 1

Answer

Mathematics, 21.06.2019 18:00

List the sides of δrst in in ascending order (shortest to longest) if: m∠r =x+28°, m∠s = 2x+16°, and m∠t = x+12°

Answers: 1

Answer

Mathematics, 21.06.2019 23:30

Which numbers have the same absolute value? choose all that apply. asap will mark at brainliest

Answers: 1

Answer

Mathematics, 22.06.2019 00:00

The letters g e o r g i a are placed in a bag . if you picked a card and knew it was a vowel , what is the probability that it is an a ?

Answers: 1

Answer

You know the right answer?

The probability density function shown models the amount of rainfall per year for a certain location...

Questions

History, 14.09.2019 00:20

Why was it important to say that “all men” were "created equal"? choose the best answer....

Engineering, 14.09.2019 00:20

List some of the performance requirements for a bottle opener....

Engineering, 14.09.2019 00:20

In addition to the shaping requirement, what additional reason might you have for excluding the glass rod from consideration?...

Engineering, 14.09.2019 00:20

For this particular design scenario, one consideration is that a shaping operation of some type must be applied to the straight rods in order to make...

Engineering, 14.09.2019 00:20

Agas turbine receives a mixture having the following molar analysis: 10% co2, 19% h2o, 71% n2 at 720 k, 0.35 mpa and a volumetric flow rate of 3.2 m3...

Engineering, 14.09.2019 00:20

A(100) silicon wafer is 700 um thick. a rectangular mask with unknown size is used to pattern the wafer before through-wafer etch. the sides of the ma...

Engineering, 14.09.2019 00:20

An ideal vapor compression refrigeration cycle that uses refrigerant-134a as its working fluid maintains a condenser at 1000 kpa and the evaporator at...

Engineering, 14.09.2019 00:20

Arefrigerator uses refrigerant-134a as the working fluid and operates on an ideal vapor-compression refrigeration cycle between 0.12 and 0.7 mpa. the...

Engineering, 14.09.2019 00:20

A250mm wide and 25mm thick plate is to be reduced in a single pass in a 2-high rolling mill to final thickness of 20mm. the roll has a radius of 250mm...

Engineering, 14.09.2019 00:20

(a) calculate the ratio of the maximum radial stresses at the edge and centre of a flat circular steel plate clamped at its periphery and subjected to...

Engineering, 14.09.2019 00:20

Acircular thin steel diaphragm having an effective diameter of 200 mm is clamped around its periphery and is subjected to a uniform gas pressure of 18...

Engineering, 14.09.2019 00:20

What other material properties should be considered for this application, and which of the provided materials would be suitable candidates for conside...

Engineering, 14.09.2019 00:20

An ideal vapor compression refrigeration cycle operates at steady state with refrigerant 134a as the working fluid. saturated vapor enters the compres...

Engineering, 14.09.2019 00:20

Determine the specific volume of superheated water vapor at 15 mpa and 1000c, using (a) the ideal-gas equation, and (b) the steam tables....

Engineering, 14.09.2019 00:20

Two litres of hot liquid at 80°c are poured into a container of mass 0.8 kg, which is at 15°c. determine the equilibrium temperature if no external he...

Engineering, 14.09.2019 00:20

Find the value of h for refrigerant-134a when p = 0.30 mpa and s = 1.0023. h = kj/kg....

Engineering, 14.09.2019 00:20

Awindow air conditioner unit is placed on a laboratory bench and tested in cooling mode using 750 w of electric power with a cop of 1.75. what is the...

Engineering, 14.09.2019 00:20

One kilogram of ice at -5°c is mixed with 2 kg of water at 18°c in an insulated copper vessel of mass 1.5 kg. at equilibrium, the vessel contains both...

Engineering, 14.09.2019 00:20

Determine the maximum possible efficiency of the following heat engines: (a) an internal-combustion engine using the atmosphere at 20°c as the heat s...

Engineering, 14.09.2019 00:20

Apetrol engine produces 20 hp using 35 kw of heat transfer from burning fuel. what is its thermal efficiency, and how much power is rejected to the am...

More questions: Mathematics Another questions