subject
Physics, 11.04.2020 04:23 amanuelwold

To understand the experiment that led to the discovery of the photoelectric effect.
In 1887, Heinrich Hertz investigated the phenomenon of light striking a metal surface, causing the ejection of electrons from the metal. The classical theory of electromagnetism predicted that the energy of the electrons ejected should have been proportional to the intensity of the light. However, Hertz observed that the energy of the electrons was independent of the intensity of the light. Furthermore, for low enough frequencies, no electrons were ejected, no matter how great the intensity of the light became. The following problem outlines the methods used to investigate this new finding in physics: the photoelectric effect.

A)Classical electromagnetism predicted that
V0 V_0 should have increased as the intensity of the incident light increased. On the contrary, it was found that V0 V_0 increased as the frequency f f of the light increased. The voltage V0 V_0 was found to obey the following linear relationship:
V0=mf?b V_{0} = mf - b ,

where m m and b b are numerical constants (representing the slope and the intercept, respectively). By comparing this equation to your answer from Part B, find an expression for the intercept b b. (Notice that mf mf in this equation changes with different light but b b is a constant of the metal.)
Express your answer in terms of ? phi and e e.

B)In a 1905 paper that later won him a Nobel Prize, Albert Einstein postulated that the energy of light was proportional to its frequency. The constant of proportionality turned out to be Planck's constant
h h: Elight=hf E_{\rm light} = hf . Using your previous results, and the equation given in Part C, find an expression for h h in terms of experimentally determinable quantities.
Express your answer in terms of the slope m m and e e.

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 11:10
Which situation will produce the greatest change of momentum
Answers: 2
question
Physics, 22.06.2019 19:20
Two kilograms of air within a piston–cylinder assembly executes a carnot power cycle with maximum and minimum temperatures of 800 k and 300 k, respectively. the heat transfer to the air during the isothermal expansion is 60 kj. at the end of the isothermal expansion the volume is 0.4 m3. assume the ideal gas model for the air. determine the thermal efficiency, the volume at the beginning of the isothermal expansion, in m3, and the work during the adiabatic expansion, in kj.
Answers: 1
question
Physics, 22.06.2019 19:50
The heater element of a 120 v toaster is a 5.4 m length of nichrome wire, whose diameter is 0.48 mm. the resistivity of nichrome at the operating temperature of the toaster is 1.3 × 10-6 ω·m. the toaster is operated at a voltage of 120 v. (a) what is the power drawn by the toaster? (b) if the cost of electricity is 12 ¢ per kilowatt-hour, and it takes 2 minutes to toast bread, how much does it cost for toasted bread? (c) when the heater element is at room temperature, is the resistivity in the nichrome wire greater than, less than, or equal to it’s resistivity when at operating temperature? explain.
Answers: 3
question
Physics, 23.06.2019 00:30
Discuss the difference between thermal energy and heat. (terrance) terrance, egolf, r., congdon, donald. physical science student text, 5th edition. bju press, 2014. vitalbook file.
Answers: 1
You know the right answer?
To understand the experiment that led to the discovery of the photoelectric effect.
In 1887, H...
Questions
Questions on the website: 13722363