subject

Chemistry, 27.04.2021 15:30 taylor3865

1. When there is light, photosynthesis can A. occur, in the chloroplast.

B. not occur, and the stomata will not be open.

C. not occur, and the stomata will be open.

D. occur, in the
mitochondria.

ansver

Answers: 1

Show answers

Another question on Chemistry

question

Chemistry, 22.06.2019 00:00

Substance x has a fixed volume, and the attraction between its particles is strong .substance y had widely spread out particles and can be compressed what can most likely be concluded about these substances

Answers: 2

question

Chemistry, 22.06.2019 14:30

Which of the following represents the ester functional group? a. -coo- b. -cho c. -cooh d. c=o

Answers: 1

question

Chemistry, 22.06.2019 21:00

Use the measurements in the table to determine which unidentified metal has the highest density. metal volume mass a 10.5 cm3 122 g b 14.2 cm3 132 g c 16.1 cm3 115 g d 12.7 cm3 126 g

Answers: 2

question

Chemistry, 23.06.2019 08:40

A20 liter cylinder of helium at a pressure of 150 atm and a temperature of 27°c is used to fill a balloon at 1.00 atm and 37°c. what is the volume of the balloon? a. 0.14 liters b. 3000 liters c. 2900 liters d. 2400 liters e. 3100 liters

Answers: 1

You know the right answer?

1. When there is light, photosynthesis can A. occur, in the chloroplast.

B. not occur,...

Questions

question

Engineering, 26.07.2019 16:10

Describe how a pitot tube works. make a sketch to show all the relevant ports...

question

Engineering, 26.07.2019 16:10

A100-mm-diameter cast iron shaft is acted upon by a 10 kn. m bending moment, a 8 kn. m torque, and a 150 kn axial force simultaneously. the ultimate t...

question

Engineering, 26.07.2019 16:10

Consider an aisi 4135 steel in which each one of its alloying elements has the average value of its range. assume that you desire the hardness for thi...

question

Engineering, 26.07.2019 16:10

Multi-processors computer operates in a server room in a building of weather station located in the mountains at altitude of 3000 m. the computer is c...

question

Engineering, 26.07.2019 16:10

Amultiple disk clutch, steel on bronze, is to transmit 4.5 hp at 710 rpm. the inner radius of contact is 1.0 in, and the outer radius of contact is 2....

question

Engineering, 26.07.2019 16:10

Why a single crystal material is anisotropic, but a polycrystal material is isotropic?...

question

Engineering, 26.07.2019 16:10

What is the effect of high oxygen content on the mechanical properties of titanium alloys?...

question

Engineering, 26.07.2019 16:10

Acold-drawn aisi 1015 steel tube is 300 mm od by 200 mm id and is to be subjected to an external pressure caused by a shrink fit. what maximum pressur...

question

Engineering, 26.07.2019 16:10

A100,000 lb elevator is supported by a stranded steel cable having a 2.5 in^2 cross-section and an effective modulus of elasticity of 12* 106 psi. as...

question

Engineering, 26.07.2019 16:10

Consider a large plane wall of thickness l = 0.4 m, thermal conductivity k= 2.3 w/m x °c, and surface area a= 20 m². the left side of the wall is main...

question

Engineering, 26.07.2019 16:10

Atransformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10 cm x 6.2 cm wide gold heat sink to its top surface. the...

question

Engineering, 26.07.2019 16:10

An incandescent lightbulb is an inexpensive but highly inefficient device that converts electrical energy into light. it converts about 10 percent of...

question

Engineering, 26.07.2019 16:10

Determine an equation for power of a pump that is function of specific weight of fluid , flow rate and fluid head, show detailed justification....

question

Engineering, 26.07.2019 16:10

Alocal dairy farmer has a water tank (much like a water tower) on her farm to hold drinking water for her dairy cows. rain water which consists of 95%...

question

Engineering, 26.07.2019 16:10

During a cooling process with dehumidification, where does the hot and humid air dehumidify? a)-on the cooling coils b)-on the walls of air ducts c)-...

question

Engineering, 26.07.2019 16:10

Asleeve bearing has an outside diameter of 1.20 in, and a length of 2 in. the wall thickness is 3/16 in. the bearing is subjected to a radial load of...

question

Engineering, 26.07.2019 16:10

Unlike steel martensite, formation of titanium martensite does not impart high hardness to the alloy. explain why....

question

Engineering, 26.07.2019 16:10

You are tasked to justify the purchase of a robot that would cost $100,000 as a fixed price, plus an additional 15% annual maintenance. this robot wil...

question

Engineering, 26.07.2019 16:10

Along homogeneous resistance wire of radius ro = 5 mm is being used to heat the air in a room by the passage of electric current. heat is generated in...

question

Engineering, 26.07.2019 16:10

Can oxygen be considered an alloying element for titanium? explain....

More questions: Chemistry Another questions

Questions on the website: 13722360